Williams Aperture Rear Sight

AS13 · February 12, 2013, 06:59:48 PM

Gave it a run today at my basic 30' sitting position. I wasn't sure if that short post front sight on the Crosman muzzle brake would cut it. If need be, there was a little adjustment to raise the front sight if necessary. After a few shots to get the feel for the sight the best five shot group measured (to the best I could figure) 3/8" X 3/8" using the H&N Sport wad cutters. I'll make some sight adjustments and try it again tommorow. So far I like it

quickster47 † · February 12, 2013, 07:09:40 PM

What is the dimensions of the rings on this target? It doesn't look to be a standard 10 meter target is why I'm asking. Also trying to get an idea of how the gun is shooting.

Carl

AS13 · February 12, 2013, 07:50:09 PM

The inner orange circle is 1/2" diameter. The green inner circle is 1" diameter.

quickster47 † · February 12, 2013, 08:10:15 PM

Thanks for the information. Now off to put some numbers into my spreadsheet.

Carl

Crosshairs · February 12, 2013, 08:12:06 PM

Nice shooting

Try a 10 shot group and see what you come up with.
Mike

arkmaker † · February 12, 2013, 10:20:44 PM

I'd take that group anyday from 30 feet!! Nice shooting.

Brent · February 12, 2013, 10:25:10 PM

Quote from: arkmaker on February 12, 2013, 10:20:44 PM
I'd take that group anyday from 30 feet!! Nice shooting.

Me too! That is a real tight group.

AS13 · February 12, 2013, 10:53:53 PM

Yep...That's the best group so far. I kinda lost count of how many rounds through the barrel so far

I'll just go by the empty tins. I'm still trying for that elusive one hole group

I found I could keep the sight "on point" a lot longer than the red dot. Just a bit more thought process with the Williams. After a while, like a red dot, you can center the front sight/dot without a lot of thought.