!322 and 2240 safety

[Jimbo]

I've been messing with the sear spring on these two guns and when I get it so the trigger pull is a little lighter I can't cock it unless the gun is on safety ( which is probably a good thing ), is this kind of normal?

[KevinP]

It is not normal. You have the spring much to light,
it can cause a accidental discharge. Even if it passes the " bump " test.
you are borderline ...

[Jimbo]

Thanks, I will stiffen it up a little then.

[Charlie51]

Very good to know!!

[Jimbo]

your so funny!

[crossliner]

The Magnum Air Power light trigger spring is good, actually, I have 2.

You can opt for a light spring and shim the bottom with a washer or 2 if it is loo light, rather than elongate it, which is palliative, as it would revert to its original length after a while.

The washer(s) can be installed via the trigger frame's peg.

You might need to sand them a bit (the sides), so they don't hit the grips.

Most often, a single thin washer works wonders.

Ace Hardware happens to carry countless fasteners and other "thingies."