Crosman Pivot pin

[Coyotehunter2011]

I have already had a post about this but my pivot pin slides to the right over time. What size bolt would i have to get to replace it? Thanks.

[arkmaker †]

Bite the bullet and order one of these from Charlie. Solved my problem of the roll pin working itself out on me.

http://mellonair.myfreesites.net/index.php?p=1_12_Solid-Pins

Rich

[ceejay]

Bite the bullet and order one of these from Charlie. Solved my problem of the roll pin working itself out on me.

http://mellonair.myfreesites.net/index.php?p=1_12_Solid-Pins

Rich

+1

Awesome parts from C.Mellon 

[cmj21973]

If you have some basic tools and the know how, you could make your own: pivot pin, safety, or left-hand safety.

Pivot pin & Safety:
http://www.crosman-air-pistol-owners-forum.com/board/index.php?topic=4523.msg44667#msg44667

Left-hand Safety:
http://www.crosman-air-pistol-owners-forum.com/board/index.php?topic=6127.msg64821#msg64821

[NorthStaR]

If you have some basic tools and the know how, you could make your own: pivot pin, safety, or left-hand safety.

Pivot pin & Safety:
[url=http://www.crosman-air-pistol-owners-forum.com/board/index.php?topic=4523.msg44667#msg44667]http://www.crosman-air-pistol-owners-forum.com/board/index.php?topic=4523.msg44667#msg44667[/url]

X2, make one. It's simple, rewarding and novel.     You only need a drill and a dremel. And something to grind.
If you haven't got a dremel, use a needle file. It just takes a little longer. Same outcome.

I made one out of an old nail and another out of an HSS drill bit. Two probe Orings and your pumpin' for peanuts!

[arkmaker †]

I made my own on my first 1377. This time I bought one from Charlie. I got the one with the nuts. They worked great until I put the wood forearm on and then they would hit. So, I cut off the threaded ends, drilled and tapped for button head screws (this is what I did on the first one I made as well). Look good, works good and give you the low profile clearance.

Rich

[0351_Vet]

I made my own on my first 1377. This time I bought one from Charlie. I got the one with the nuts. They worked great until I put the wood forearm on and then they would hit. So, I cut off the threaded ends, drilled and tapped for button head screws (this is what I did on the first one I made as well). Look good, works good and give you the low profile clearance.

Rich

Great idea Rich.