inaccuracy

[1377x]

Cheap and easy solution to the wobbly stock -

there's the mod i was talking about finally

[cmj21973]

Cheap and easy solution to the wobbly stock -

It's one solution.
Cheaper maybe.  
Easier, I don't think so.

[1377x]

It's one solution.
Cheaper maybe.  
Easier, I don't think so.

same thing i said i didnt want miss the frame and have to make another hole
if you know what you are doing though it looks like a solid way to rid the wobble

[mcc1961]

It works and my stock is more secure,thanks for the tip.

[1377x]

It works and my stock is more secure,thanks for the tip.

what works?

[mcc1961]

The screw in the bottom of the stock.It works great to tighten up the play in it.

[1377x]

The screw in the bottom of the stock.It works great to tighten up the play in it.

thanks for the clarification
looks like a solid mod
was it hard to do?

[mcc1961]

Just took a few minutes.

[1377x]

what size screw did you use?

[mcc1961]

Just an old metal screw I had in my toolbox.

[quickster47 †]

The screw is a great solution but then some rolled tape or foam tape in the correct place works just as well and does so without needing you to mess with a drill.

Carl

[1377x]

The screw is a great solution but then some rolled tape or foam tape in the correct place works just as well and does so without needing you to mess with a drill.

Carl

good idea
only have a problem with my early phase 2 grip frame only 1 little nub to go in the rail.i did see the 1399 stock changed when the phase 3 gripframe came out,it has 2 little nubs that go into the rail slot
the old 1399 had a shorter track probably because there was only

[1377x]

this is what i am talking about when i say nubs
the phase 2 1399 stock wont go on a phase 3 grip frame
and if you put a phase 3 1399 stock on a phase 2 grip frame there is extra wobble
the 1399stock i have on my p-rod is a tight fit no wobble barely enough room for the factory pad if there is any room