What work did you just do?

[bgmcgee]

I just f@$"ed up my bulk valve for my 2260 tube project damn it anyhow. Been busy doing repairs ten guns last month.

Bummer.   

[WyoMan]

I feel your pain Mike...can't tell you how many valves and valve parts I have in the bone pile

[Crosshairs]

Bummer.   

I feel your pain Mike...can't tell you how many valves and valve parts I have in the bone pile

It was my fault i should be able to fix it but it's going to be a pain. I just might order another.
                                 Mike

[Ryan]

I have gone through the various discussions in this forum and found them to be very informative and innovative as well.

I thought someone was saying that he put a washer between the pump arms at the linkage in a 13xx, but I cannot relocate that thread. Can someone shed the light on this.

[mudduck48]

I have gone through the various discussions in this forum and found them to be very informative and innovative as well.

I thought someone was saying that he put a washer between the pump arms at the linkage in a 13xx, but I cannot relocate that thread. Can someone shed the light on this.

That be me. Get a small thin washer and take a small grinding bit in your Dremerl and open up the hole so your pin will fit through it. I used a dial caliper and measured the width of the slot in the front barrel band and the width of the pump arm and sanded the washer down so when installed it would leave about 2 to 3 thous. clearance. Here is a picture. Good luck.

[Ryan]

Duck thanks for the response. I guess the shimmer is to prevent the pump arm to have side play after extensive pumping, right?

[mudduck48]

If you have extra side to side play in your pump arm, this will fix it. I noticed it when I went to a longer barrel on my 1322. I had changed the front barrel band and wound up with play. You will also find it on the 2289G doomsday back packer.

[BigErn]

Did some work on the 2260 this morning.

Polished the breech
Added a GMAC brass extended bolt
Swapped out the bolt handle for a Chongman handle (Spheres)
Polished the tube, barrel, and grip frame again
Swapped out the BKL mount for silver B-Square rings

Here she is 

[breakfastchef]

Did some work on the 2260 this morning.

Now that is officially yummy!

[Noah]

Now that is officially yummy!

Damn, that is nice - well done!

[bgmcgee]

Yup Big E it's official.  That's one sweet shooter.  

[Davio]

That IS sweet.     And I thank you for an idea it spawned.   

[BillK]

That's gotta be the longest polished tube in the neighborhood.  Looks great.

[targettgii]

Damn that is a sweet looking shooter BigErn.

[KevinP]

   ...  NICE  !!!