Print Page - 1377 barrel band

Title: 1377 barrel band
Post by: doncoth on July 10, 2011, 04:05:07 AM

I have a question for you guys. Which do you prefer for the pivot pin in place? Retaining rings or using a set screw. I am working on making some in the near future. Any suggestions will be appreciated thanks for your help.

Title: Re: 1377 barrel band
Post by: yel01z06 on July 10, 2011, 04:16:49 AM

would the set screw just go through the front of the band and rest in an indent in the pin? if that is what you are talking about i would rather go that route then c or e clips

Title: Re: 1377 barrel band
Post by: mr007s on July 10, 2011, 04:23:57 AM

I think the set screw thru the face of the band makes a much neater assembly.

Title: Re: 1377 barrel band
Post by: slothart on July 10, 2011, 04:49:02 AM

my vote is for set screws.

Title: Re: 1377 barrel band
Post by: eric on July 10, 2011, 05:44:42 AM

1 or 2 (each side) set screws with either a dimple or flat where the set screw contacts the pivot pin so it doesn't "walk"

Title: Re: 1377 barrel band
Post by: L.O. Little on July 10, 2011, 07:18:50 AM

Don, check your PMs. I sent you a link that you might find interesting.

Crosman Air Pistol Owners Forum

Crosman air pistol - General => Crosman air pistol - General discussion => Topic started by: doncoth on July 10, 2011, 04:05:07 AM