I have a Chavka barrel band and I can't find the right hex wrench to use in the tiny hex screw that holds the pump arm pivot pin. The only thing I know is it isn't 0.050 like the breech screw the hole is bigger - does anybody know what size wrench?
(http://i80.photobucket.com/albums/j169/marc780/chavka1.jpg)
Also there is a threaded hole in the barrel band that appears to be for a screw to hold into the barrel. Is there supposed to be a screw in the hole? What size? If anybody knows I'd be grateful.
Quote from: markasaurus on September 08, 2012, 07:30:34 PM
I have a Chavka barrel band and I can't find the right hex wrench to use in the tiny hex screw that holds the pump arm pivot pin. The only thing I know is it isn't 0.050 like the breech screw the hole is bigger - does anybody know what size wrench?
1/16"
(http://i80.photobucket.com/albums/j169/marc780/chavka1.jpg)
Also there is a threaded hole in the barrel band that appears to be for a screw to hold into the barrel. Is there supposed to be a screw in the hole? What size? If anybody knows I'd be grateful.
There should be a set screw in there, size 6-32, same as the barrel one ,1/16" hex wrench for it.
x2 What Chong said. :-*
thanks much
I am just going to threw this out there when i am working with small allen wrench's i like to buy new ones as they can wear out pretty fast and strip screws. I buy mine at Ace Hardware in with the nuts and bolts they cost under 50 cents each. It does not hurt to have extra i like some for the tool box and some for the shooting bag.
pc
Quote from: PC77 on September 09, 2012, 06:32:38 PM
I am just going to threw this out there when i am working with small allen wrench's i like to buy new ones as they can wear out pretty fast and strip screws. I buy mine at Ace Hardware in with the nuts and bolts they cost under 50 cents each. It does not hurt to have extra i like some for the tool box and some for the shooting bag.
pc
A worn tool is the worst thing you should use on hex fasteners. I prefer to use a good brand of hex wrench, Bondhus or Wiha and do not like the ball end type. They wear very quickly.
The ball end is just for running the threads up quickly, not for torque. Loosen and tighten with the short end.
Cheers,
seams like you can never have enough alan wrenche's. ;D
pc
(http://i246.photobucket.com/albums/gg95/51colt/Mobile%20Uploads/th_IMG_3657.jpg) (http://s246.photobucket.com/albums/gg95/51colt/Mobile%20Uploads/?action=view¤t=IMG_3657.jpg)
Quote from: PC77 on September 10, 2012, 12:20:13 AM
seams like you can never have enough alan wrenche's. ;D
pc
(http://i246.photobucket.com/albums/gg95/51colt/Mobile%20Uploads/th_IMG_3657.jpg) (http://s246.photobucket.com/albums/gg95/51colt/Mobile%20Uploads/?action=view¤t=IMG_3657.jpg)
;D ;D ;D Good on ya!