• Welcome to Crosman Air Pistol Owners Forum.

Are the trigger groups from a Prod and 1701P the same?

Started by Tacoma, Today at 12:47:05 PM

0 Members and 1 Guest are viewing this topic.

Tacoma

I'm looking at upgrading the trigger in a new 2300T.   In looking at pictures, these frames/trigger groups look to be the same. Are they? If not, is one better than the other?
I'll assume I'll need a new slotted hammer for either as well?
Thanks in advance!
Dave

CraigH

First the hammer.   A slotted hammer, slotted at the top front, is required for the use of rearward located 4-48 screw breeches.

What is needed is a hammer without the wasp-waist profile.

Since your pistol is a 2300T, both features above are needed.

The P-Rod and 1701 grip frame assemblies (GFA) are the same.  Many refer to these as the 1701 GFA - I prefer to called them P-Rod GFA's as their part number is 2220-103, and the P-Rod is model number BP2220.
Craig
Lone Tree, Colorado

With freedom comes a terrible responsibility

ped

not sure if anyone is doing the slotted hammers for them
might have to do the way and use jb weld in the waste
another way i have done it is to weld the waste at the bottomthen clean up
the release face i kept cool in a wet rag and more spot built up than continouse welding
I am also active on https://ukchineseairgunforum.com