HDD for the #2240

[oletom]

I know I have seen the HDD (hammer debouncer) some where here  but am unable to find it...anyone can help please......thanks in advance

[quickster47 †]

Only place I've seen them for sale is Airguns of Arizona.  Look on the left side under Crosman, then under Custom Parts.

http://www.airgunsofarizona.com/

Carl

[oletom]

thanks carl,,,,,,u feel that they are worth the 20 bucks?

[1377x]

a lot of people say they are worth it

[quickster47 †]

thanks carl,,,,,,u feel that they are worth the 20 bucks?

Personally, I do think they are worth it although there have been lots of mixed reviews about them.  For me, I did and do get more shots per powerlet using a HDD and as a plus feature, the HDD will actually make your gun quieter.

I wish they were not so expensive because some times it is hard to justify $20 for that little piece of plastic tube.  If they were $10 they would sell four times as many in my opinion.

Carl

[bdb12586]

Carl, is it made out regular plastic?
What kind of additional shot count do you get?
I made one the other day out of a piece of rigid ¼ plastic tube, I   can’t tell for sure if it works or not. Doesn’t seem any quieter but sounds crisper. Don’t know about shot count didn’t keep track. I’m way to cheep to spend $20 on one.

[mr007s]

I have made several from  white nylon, seem to be working well.

[tatsumi]

I did my own thing on my as2250xt, 6mm air tube pipe at 6mm long inserted into the hammer spring. Made that funny noise the spring makes stop and up'ed my shot count up to around 25+ shots. I would like to give one a try but at $20 im happy with my method.

[dicktracey]

just courious has anybody tried HDD on pumper? Could possibly get multiple shots from say 10 pumps.

[arkmaker †]

I made some yesterday out of Delrin AF. Still need the hole drilled and to be sloted. I had originally thought this would be my miracle material, but now I am not so sure. I think it is still to hard. Only time will tell. The last one I made out of white delrin is still holding up 
Rich

[mr007s]

Rich, I didn't machine the slot on mine. After the hole was located and drilled I stood it up and used an Exacto knife and sliced it. Working good so far. i can't say the slot is all that important.

[arkmaker †]

Rich, I didn't machine the slot on mine. After the hole was located and drilled I stood it up and used an Exacto knife and sliced it. Working good so far. i can't say the slot is all that important.

Actually, that is how I did it too. I used my dremel with a 1/8" drill bit and did the hole first, then cut the angled slot with the exacto. Works Slick. I should try out the Delrin AF tonight, but I think it will be to brittle.
RIch

[bdb12586]

the 1/4" tube I used seemed to work good for about 60/70 shots then the hole that the hammer pin goes in ripped out and I had to take it apart to remove it. I can see that it would be nice to have if it were like $5 but I'm not spendin 20. so If I can't find a material to hold up I'm just going to skip it, sooooo if you have something that is holding up that I don't need to turn in a lathe let me know so I can give it a try.
brian

[mr007s]

I found some 5/16" OD white nylon at work that I used. It did need some lathe work for turning to .260 or so and drilling and parting off.