2240 C02 Cap?

[WheelchairMitch]

Hey guys just wondering what you guys think is the best/easiest to use aftermarket C02 cap for a 2240. Kinda gettin tired of carryin a flathead around everywhere I shoot. Your opinions are much appreciated.

[eric]

mr.007 has  some nice tri-wing  gas caps that i  would  recommend                                                                                                                           

[JEBert]

You shouldn't need a screwdriver to tighten the OEM cap.  If you need one to make the Co2 cart seal, you need a new seal in the front of the valve.  Hand tight should be fine.
However, I do recommend Mr007's tri-wing cap.  I have one in stainless.  They look great and are easier to turn.
Cheers,
Jerry

[WheelchairMitch]

awesome those look perfect. How do i go about getting one? thanks

[JEBert]

Mr007’s is a member on this forum.  You can do a search for his tri-wing posts or just PM him.
Cheers,
Jerry

[mr007s]

Good evening mitch, I have several in stock, both SS and brass. PM me for details.

[QB78Guy]

JEBert where did you get the rear sight for your 2240 and did you have to mod it to fit the breech?

[JEBert]

It is the Industry Brand Rear Sight.  I got it from Archer Airguns for around $16  + shipping.  It does not need modding to fit the breech.  However, with the sight at its lowest, my shots were going high at 5 meters so I did some concave rounding on the bottom to let go lower to the steel breech because I installed it in front of the bolt.  Then remounted it to the rear and I wouldn't have had to mod it for it to mount there.  While I was relieving the underside, I ground into the spring and had to take it apart, backbore the hole from the top, and find a larger spring that would stay inside.  Like I said, with the back of it hanging off of the rear of the breech, it doesn't need modding but shooting at 5 meters it needs to be about as low as it will go with the front sight I am using.
Cheers,
Jerry

[QB78Guy]

thanks for the info, I have been looking for a cheaper (price) rear sight and yours looks really nice!

[shaneone]

Hey Mr.007 - am looking to get one of your Stainless Steel tri-Co2 caps. How can I get one or contact you? Thanks Bud!!

[PLauGE]

Good evening mitch, I have several in stock, both SS and brass. PM me for details.

could you pm me with a price for a as tri-wing, that's if you ship to the uk