1322 and Walmart

[DHunter]

Got to spend a little time with my new gun, made two adjustments to the open sights, painted the front blade site and she shoots where I aim.  Pretty happy, seems to pack a pretty good punch.
This will be my new woods buddy, not planning many external changes, at least not anything that will keep it from fitting my holster.   

That was quite a few years ago, so let me make sure:  Is that the same one as https://www.crosman.com/elite-pistol-holster ?  If so, I'll order one.

[cherokeesteve]

Yes, that's it. I have one for my 1377, nice holster in my opinion.

[DHunter]

Well, it arrived, but the 1322 does not fit through the hole in the bottom.  With some effort, I can get it to stick through the hole only about one inch, not five inches as shown in the picture.  The pump arm is much too big to fit through.  I could return it, but I really want this to work, so I might try to modify it.  Any comments welcome.

[BillK]

I have posted this before, but this is the holster in action, it works pretty good.  It is just the $7 crosman holster you get off the shelf, cut a few stitches out of the bottom, then I installed a black zip tie to keep it from ripping out further.  The pictures are my 1377 before I scoped it.

[DHunter]

Thankyou, BillK.   Somehow I had missed the part about the modification.  It looks easy enough though.  Thanks again.

Edit, a few weeks later:  Done.   

[Flex]

Love these revitalized threads ! Made me go to the shop and take my 1322 out and fondle it for a while . Too cold to go out shooting tho . Thread has a couple of topics that are frequent subjects of discussion, simple trigger mods and holsters for 13xx pumpers. I'm sure there are "stickies" for them but I'll comment anyway.

I did a simple trigger mod several years back that I found to improve the trigger action greatly!  Check out this link to the thread. https://www.crosman-air-pistol-owners-forum.com/board/index.php/topic,9044.msg120143.html#msg120143
Not the equivalent of a p-rod trigger but an improvement to be sure .

RE: making the Crosman holster for their AirSoft guns fit the 13xx series, indeed it is simple! The zip tie method is super simple but leaves that squarish chunk of plastic along the edge of the holster. I used a small carriage bolt, washer and nut arrangement. The smooth head of the carriage gives a touch of class IMHO . Kinda bulky on the back side and I had to carefully remove the excess bolt length and about half of the nut with my Dremel tool. (OK fine, less classy there and some extra work). Another option would be to use brass Chicago screws as that would look nice too.
Flex