• Welcome to Crosman Air Pistol Owners Forum.

Need a Measurement

Started by mr007s, September 26, 2012, 11:23:07 PM

0 Members and 1 Guest are viewing this topic.

0351_Vet

Quote from: arkmaker on September 27, 2012, 02:04:34 AM
.312" diameter and cupped on the end

You beat me to it...photos and all. Great job.  :-*
Marauder  .25 / CP 4-16x56mm AO Mil-Dot & Marauder P-Rod
Disco .22 / Leapers 3-12x44mm AO  Mil-Dot / Disco Sleeper Carbine
Katana .22 / CP 4-16x56mm AO Mil-Dot
2260 / CCS 2400KT / 2300KT / 1701 / 1377 / 1322 / EB22 / Benji 132 / Benji 422


<'((((><      ΜΟΛΩΝ ΛΑΒΕ


1377x

this is the first i have heard about an issue with one of your caps
i am interested in the outcome im thinking of adding a 2400 to the arsenal.
closed mouths dont get fed

eric

Quote from: mr007s on September 27, 2012, 01:40:24 AM
I will do that. When the rod is installed I check alignment with a dial indicator to make sure all is straight. If it is crooked now it will probably have been bent. The rod is coated with red loc-tite and pressed in place .300" deep when they are assembled.

Is the stock rod 3/8" OD? 1/2" OD?
I am thinking a 1/2" would contact more area of the cart and stabilize it better.
i might use grease or something to allow the gas cap to turn more freely when pressure is applied rather than have the two pieces be/act as one
TOO many freaks and NOT enough circuses

Fronzdan

I got 1.565" length and 0.309" diameter.


mr007s

Thanks for all the helpful info. I will make the next couple rods 1.575 to bring them more in line with the factory cap. Decided to stay with 3/8 Diameter instead of going to 1/2.

BDS

1.565" on mine!

Your adapter with .060" length of "squish" of the cartridge to seal s/b fine?
Brian