What work did you just do?

[Motorhead]

Finally got my Mellon adapter! Using the flashlight as a foregrip 

You got STYLE ... GREAT style, well done indeed 

[chongman]

I Finished removing the mold lines and stripped the paint off of a grip frame today. Still to do is the barrel band. Hope to finish that tonight/tomorrow than it's off to be powder coated.

forgot the picture!

[WyoMan]

I Finished removing the mold lines and stripped the paint off of a grip frame today. Still to do is the barrel band. Hope to finish that tonight/tomorrow than it's off to be powder coated.

forgot the picture!

Is that project A.L.I.C.E. not sure what your building 

[targettgii]

Nice looking rig Big Ern and very nice work Chongman.

[BigErn]

I Finished removing the mold lines and stripped the paint off of a grip frame today. Still to do is the barrel band. Hope to finish that tonight/tomorrow than it's off to be powder coated.

forgot the picture!

Thanks again for the nice compliments guys! Chong I love this pic 

[chongman]

Huge mess

I'm going to use the frame, trigger, and barrel band to build a 2400 pistol with forearm

[YSYEO]

I did a reseal and hammer replacement on my son-in-law's 38T.

Here is how it started.


Here are the old and new parts laid out.


The replacement hammer required a little grinding where it meets the sear, in order to engage properly.


Here's the finished result.


BTW, when the assembly instructions for the valve say "finger tight only", it's important.
Too tight and it won't release any CO2.

[WyoMan]

Nice work YSYEO 

[chongman]

Nice work on the 38T 

[targettgii]

.Nice work on that pistol YSYEO. I want to get one of those a 38c though keep missing them when they come up for sale don't last very long

[Fronzdan]

Nice work YSYEO!  What is that Godawful looking crud in the upper right?!?

[YSYEO]

Nice work YSYEO!  What is that Godawful looking crud in the upper right?!?

That would be the end seal for the CO2 cart.   It wasn't actually bad when I started, but it comes out in pieces.

[1377x]

That would be the end seal for the CO2 cart.   It wasn't actually bad when I started, but it comes out in pieces.

where did you get the parts?

[YSYEO]

where did you get the parts?

I usually get my stuff from Rick Willnecker at Precision Pellet.
http://www.airgunshop.net/contactus.html

He had a replacement hammer for $10 and the seal kit was $19.50.   The kit includes a new piercing pin as well as the o-rings and valve seat.   When Crosman changed the end seal on these guns, they also updated the piercing pin.

I wish I had ordered 2 kits, though, because while I had this gun apart on the bench, I found another 38T (.22) in a box and brought it home.  And guess what?   It leaks.   I have some O-rings, and I already tried flipping the valve seat around but no luck.    I may try turning a new seat on the lathe, but if that doesn't work,  I'll buy another reseal kit.  No biggie, his shipping is quite reasonable.

[1377x]

good place to shop
i was just checking to se many dont know about rick.