What work did you just do?

[ped]

pics of how i've fitted an ldc to my bluestreak what i've done is modified an eb22 adapter by milling the dovetail of the bottom of it then slotting it so the pump arm clears
the adapter is a close engineering fit so a rubber persquading tool was used to tap it on ,to remove it i had to drill and tap the front so a grub screw could be screw in which pushes against the plug cap and pushes it off
i had to make two cut outs to clear the rear roll pin and replaced the front one with m5 grub screws that i tapped all the way through the main tube and plug
the pump arm forend had to have a slight ammount of adjustment so it cleared the adapter
heres what i started with
will have to do another post to show the end result
ped

[ped]

pics of how it turned out
ped

[quickster47 †]

Wow, now that is definitely very innovative.  How is it working for you?

Carl

[Crosshairs]

Very cool and nice job.
                Mike

[chongman]

Ya, very slick way to go about it 

[ped]

cheers chaps i'm going to take it to work tomorrow to test it fully but from the couple of test shots i did earlier it works quite well at collecting "lead dust"
ped

[targettgii]

Very cool ped can't wait to hear the full report or lack of that is .

[BDS]

ped old boy... I'm proud of you, you made it work!

That issue has been the bane of the Benji and Dan pumpers and appears you now have it sussed! Congrats

[breakfastchef]

Great solution, ped. The engineering of that adapter is outstanding. Didn't this project come about because you were having trouble contacting Ballistic Enterprises?

[crossliner]

pics of how i've fitted an ldc to my bluestreak what i've done is modified an eb22 adapter by milling the dovetail of the bottom of it then slotting it so the pump arm clears
the adapter is a close engineering fit so a rubber persquading tool was used to tap it on ,to remove it i had to drill and tap the front so a grub screw could be screw in which pushes against the plug cap and pushes it off
i had to make two cut outs to clear the rear roll pin and replaced the front one with m5 grub screws that i tapped all the way through the main tube and plug
the pump arm forend had to have a slight ammount of adjustment so it cleared the adapter
heres what i started with
will have to do another post to show the end result
ped

Looks topnotch yes sir 

[DaveB50]

Great job, looks good on the Blue Streak.

[ped]

well tested it today and looks like a rethink is required its super quiet but groups like a blunderbuss at 50yds
with the ldc on poi moved about 12" high to the right about 6" and groups were about 2" i actually saw pellets corkscrewing through the scope when the sun was shining(rare thing sun in yorkshire)
ped

[WyoMan]

Saw some stuff laying around that looked like it would fit together
Hmmm....wonder what this is going to be 

[rhg]

just installed a TKO trigger on my 2240...It feels nice a little thin though

[Cwlongshot]

I just ordered a FTP for a future project, some fancy O rings (Crosman) and a rebuilding kit for my ORIGINAL Blue streak!  I hope its a quick ship... after all this time I NEED to shoot the streak!! 

CW